Crestron-electronic TPMC-8X-BTP Uživatelský manuál stáhnout pdf (Strana 8)

Internal Battery Pack for TPMC-8X Crestron TPMC-8X-BTP

Setup

Charging

NOTE: A Lithium Ion (Li-Ion) battery typically provides 300-500

charge/discharge cycles.

There are two ways to charge the TPMC-8X-BTP:

• Install the TPMC-8X-BTP in a TPMC-8X touchpanel and connect

the touchpanel to an AC source using its AC adapter or

• Install the TPMC-8X-BTP in a TPMC-8X touchpanel and mount

the touchpanel on an AC powered TPMC-8X-DS Docking

Station/Charger (sold separately).

NOTE: The battery pack may take up to three hours to charge in a

powered touchpanel if the panel is in use during charging.

NOTE: When the external battery pack (TPMC-8X-BTPE, sold

separately) is attached, both the internal and external battery packs charge

simultaneously.

Installation

Use the following procedure to install the TPMC-8X-BTP in a TPMC-8X

touchpanel:

1. Place the touchpanel screen-side down on a clean, soft surface.

2. Remove the two Phillips head screws that hold the internal battery

compartment cover on the rear of the touchpanel.

3. Place the TPMC-8X-BTP in the battery compartment oriented so

the multi-pin connector is in the upper left corner.

4. Carefully connect the multi-pin connector of the TPMC-8X-BTP

with the corresponding connector inside the battery compartment

(refer to illustration on the following page).

4 • Internal Battery Pack: TPMC-8X-BTP Operations & Installation Guide – DOC. 6556A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Crestron-electronic TPMC-8X-BTP Uživatelský manuál Strana 8